Installing The Vga Module; System Board; Removing The System Board - Dell PowerEdge T430 Owner's Manual

Removing the control panel assembly cover

Installing the VGA module

Installing the VGA module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the
Steps
1. Align the slots on the VGA module with the VGA connector and hooks on the control panel board.
2. Press down on the VGA module until the hooks snap into place.
3. Install the control panel assembly cover.
4. Install the control panel.
Next steps
1. Install the control panel assembly cover.
2. Install the control panel assembly.
3. Follow the procedure listed in
Related Links
Installing the control panel assembly cover
Installing the control panel assembly
Preparing a system for conversion from tower mode to rack mode
Removing the VGA module

System board

Removing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Keep the #2 Phillips screwdriver ready.
3. Follow the procedure listed in
Safety instructions.
After working inside your
Safety instructions.
Before working inside your
system.
system.
139