Installing The Control Panel Assembly - Dell PowerEdge T430 Owner's Manual

Figure 57. Removing and installing the information tag
1. information tag
3. slot
Related Links
Preparing a system for conversion from tower mode to rack mode

Installing the control panel assembly

Installing the control panel assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Keep the #2 Phillips screwdriver ready.
Steps
1. Replace the blank information tag in the new control panel with the information tag retained from
the old control panel.
NOTE: Information tag lists system information such as Service Tag, NIC, MAC address, and so
on.
2. To install the information tag, push the information tag into the control-panel slot.
3. Connect the control panel cable and the control panel USB cable to the control panel module.
4. Align and insert the control panel into the control panel slot in the chassis.
5. Secure the control panel to the chassis using the screw.
6. Connect the control panel cable and the control panel USB cable to the system board.
Safety instructions.
2. tab (2)
131