Quick-Release Latch Rack Ear Assembly - HP ProLiant DL120 Gen9 Maintenance And Service Manual

To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 30).
o
Remove the thumbscrew rack ear assembly.
4.
To replace the component, reverse the removal procedure.

Quick-release latch rack ear assembly

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 29).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 30).
o
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Remove the security bezel (optional)" on page 29).
Removal and replacement procedures 64