Programme End; Removing Laundry/Switching Off The Appliance - Bosch WAK2020SME Instruction Manual And Installation Instructions

To end the programme, set the
programme selector to 0 Spin/
[ Empty or select a spin speed. Then
press the /Pause A button.
Start

Programme end

appears on the display panel and
End
the Start/Pause button indicator lamp is
off.
If the 9 symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to
2.
The appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door
■
and detergent drawer open so that
any residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
If the display panel goes off at the
■
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
.
Off
Operating the appliance
en
21