Setting The Signal - Bosch WAK2020SME Instruction Manual And Installation Instructions

M

Setting the signal

i n g S e t t
1. Activate the setting mode for the signal volume
Set to Ú.
2. Set the volume for the button signals (depending on the model)
Press the button repeatedly until the desired
volume is reached.
3. Set the volume for the information signals
Turn the dial one position
to the right.
t h e
Press and hold the 0 button and turn one
position to the right.
Press the button repeatedly
until the desired volume is
reached.
s i g n a l
Press and hold the button for approx.
five seconds until the display elements
light up. Setting mode is activated.
Go to point Set to Ú to exit the setting mode for the sig-
3 or nal volume.
Set to Ú to exit the setting mode for the signal
volume.
Setting the signal
en
23