Table of Contents
Advertisement
en Basic operation
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End" .
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 28
¡ The programme end time is set
and activated.
→ "Buttons", Page 22
Press
.
1.
The activated programme end time
is paused.
Press
until the display shows
2.
the required programme end time.
Press
.
3.
The changed programme end time
is activated.
13.10 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press
30
To resume the programme, after
3.
the desired soaking time, press
.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
5.
13.12 Cancelling the pro-
Press
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
– If the water level is high, start
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
.
.
.
gramme
.
the Sköljning (Rinse) pro-
gramme.
the Centrifugering (Spin) pro-
gramme or select a suitable pro-
gramme for draining.
→ "Programmes", Page 23
Advertisement
Table of Contents
