Water Inlet - Bosch WAK2020SME Instruction Manual And Installation Instructions

The following are available from
Tip:
specialist dealers/the after-sales
service:
An extension for Aqua-Stop or cold
■
water supply hose (approx. 2.50 m);
order no. WMZ2380, WZ10130,
CZ11350, Z7070X0
A longer supply hose (approx.
■
2.20 m) for standard model

Water inlet

:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
Observe the following when connecting
the machine:
Notes
Only operate the washing machine
■
using cold mains water.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Positioning and connecting
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
100 kPa (1 bar)
At least
1000 kPa (10 bar)
Maximum
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 m) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model:
Standard
■
Model:
Aqua­Secure
■
Model:
Aqua-Stop
■
en
35