Programme Default Settings; Temperature (Temp °C); Spin Speed (Rpm 0); Ready In Time (Ready In) - Bosch WAK2020SME Instruction Manual And Installation Instructions

Programme default settings

en
0
Programme default
settings
P r o g r a m m e
The temperature, spin speed and
programme duration ("Ready in" time)
for all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.
Temperature (Temp °C)
Depending on the programme
progress, you can change the preset
temperature (in °C) before and during
the programme.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The maximum temperature that can be
set depends on the programme which
has been selected.
Overview of programmes ~ Page 13

Spin speed (rpm 0)

Depending on the programme
progress, you can change the spin
speed (in rpm; rotations per minute)
before and during the programme.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
Setting – – – 0 : Rinse hold = without
final spin, the laundry remains in the
water after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
16
t d e f a u l
The maximum speed that can be set
depends on the model and programme
that have been selected.
Overview of programmes ~ Page 13
i n g s s e t t

Ready in time (Ready in)

When you select the programme, the
relevant programme duration is
displayed.
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end ("Ready in" time) can
be preselected in increments of one
hour (h = hours) up to a maximum of 24
hours.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The programme duration is
Note:
included in the selected "Ready in" time.
After the start, the preselected time e.g.
is displayed and the time counts
8 h
down to the start of the wash
programme. The programme duration is
then displayed, e.g.
(hours:minutes).
Changing the preselected time:
You can change the preselected time
after the start of the programme as
follows:
Press Start/
1.
Press the
2.
repeatedly until the required number
of hours is displayed.
Press the
3.
Adding laundry while the preselected
time continues running:
Press Start/
1.
2:30
Pause
A
button
"Ready in"
/Pause A button.
Start
Pause
A