Change The Programme Default Settings; Select Additional Programme Settings18; Placing Laundry Into The Drum; Measure And Add Detergent And Care Products - Bosch WAK2020SME Instruction Manual And Installation Instructions

Operating the appliance
en
Change the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
Programme default settings ~ Page 16
Overview of programmes from
~ Page 13
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is active.
The settings are not saved when the
appliance is switched off.
Additional settings ~ Page 17
Overview of programmes from
~ Page 13

Placing laundry into the drum

:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
18
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
Observe the specified maximum
■
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
Place presorted items of laundry
1.
unfolded in the washing drum.
Make sure that no items of laundry
2.
are trapped between the washing
machine door and the rubber seal,
and close the door.
The Start button indicator lamp flashes
and the programme settings continue to
be displayed on the display panel one
after another. It is possible to change
the settings.
Measure and add detergent
and care products
Caution!
Damage to the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain removers,
prewash sprays, etc.) may cause
damage if they come into contact with
the surfaces of the washing machine.
Do not allow these agents to come into
contact with the surfaces of the washing
machine. If necessary, immediately wipe
away spray residue and other residues/
droplets with a damp cloth.