JETWAY G03-NMF93-F User Manual page 27

USB hardware delay and time-out:
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. 'Auto' uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor. The optional settings: [Auto];
[Manual].Select [Manual] you can set value for the following sub-item: Device
Power-up delay in seconds, the delay range in from 1 to 40 seconds, in one
second increments.
► SMART Settings
Press [Enter] to make settings for SMART Self Test. The optional settings are:
[Disabled]; [Enabled].
► Super I/O Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
► COM1 Port Configuration/ COM2 Port Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
► Parallel Port Configuration
Parallel port
Use this item to enable or disable Parallel port (LPT/LPTE)
Change Settings
Use this item to select an optimal setting for super IO device.
Device Mode
Use this item to change the Printer Port.
CIR Controller
Use this item to enable or disable CIR controller.
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
► PC Health Status
Press [Enter] to view hardware health status.
► Second Super IO Configuration
► COM3 Port Configuration /COM4 Port Configuration / COM5 Port
Configuration /COM6 Port Configuration
Serial Port
Use this item to enable or Disable serial port (COM).
Change Settings
23