Sharp FACSIMILE UX-P410 Operation Manual page 117

INCORRECT FILM/
CHECK FILM
LINE ERROR
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
MEMORY PRINTING
NEAR END OF FILM/
REPLACE FILM
NO DATA
OFF HOOK
ON HOOK DIAL
OVER HEAT
The wrong type of imaging film is loaded in the
machine. Printing is not possible. The machine can
only print when SHARP UX-9CR imaging film is
loaded.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page 73.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory on page 50). If you
are attempting to transmit from memory, see If the
memory becomes full on page 40. If you are copying,
see If MEMORY IS FULL appears on page 51.
The fax is preparing to or printing out a document
from memory.
This message appears approximately 3 m from the
end of the imaging film (approximately 10 pages can
still be printed), and alerts you that you will soon need
to replace the film.
This appears if you attempt to search for an auto-dial
number when none have been stored.
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
The key has been pressed and the fax machine
is waiting for you to dial.
The print head has overheated. Operation can be
continued after it cools. If overheating frequently
occurs, try changing the print contrast setting to
LIGHT (see page 16).
Messages and Signals
79