Attach The Power Cord; Print A Status Page - Kyocera FS-6700 User Manual

1.4. Setting Up and Interfacing

10. Attach the Power Cord

11. Print a Status Page

1-26
1. Check that the power switch is off.
2. Plug one end of the power cord into the receptacle at the back of the printer.
3. Plug the other end into the wall outlet.
Power Cord
Test that the printer works by printing out a status page as follows.
1. Switch on the printer's power. The message display should indicate Self test.
Note
When the printer is first switched on after the toner container is installed, there will be a delay of
several minutes (approx. 10 minutes) before the printer will be ready to print. During this period,
the toner indicator will flash and the message display will show Please wait.
2. Wait until the ON LINE indicator is also lit and the message display indicates Ready.
3. Press the STATUS key. The printer should print a page listing the positions of margins, memory
allocation, and other information.
A sample status printout is shown in Chapter 2.
Power Cord
Receptacle