Keypad Reset; Factory Default - Honeywell TUXWIFIS Installation And Setup Manual

Keypad Diagnostics and Calibration Tests (cont'd)
Select the icon for Z-Wave Basic Command Set On
switches and receptacles.
NOTES:
This command does not control door locks or any other security enabled devices.
•
This test may cause lights and thermostat settings to change."
•
Select the icon for Z-Wave Basic Command Set Off
switches and receptacles.
NOTE: This test may cause lights and thermostat settings to change.
Assign Router: Do not use unless instructed by your dealer or a Honeywell representative.
Select this Z-Wave Route test to assign the path for the Z-Wave devices in the network.
Press on the first number field and enter the node number (between 1-232) that you wish to set the first node
•
to.
Press on the second number field and enter the node number (between 1-232) that you want the first node
•
number to route to.
Press the Assign Router test icon. If route was successful, the message "Transmit complete" is
•
displayed. If the route could not complete successfully, the message "Transmit no ACK" is displayed.
NOTE: Nodes must be in the keypad Z-Wave list prior to selection.

Keypad Reset

Press the Setup , System setup
code. Press the Keypad Reset
to reset? " Select Yes or No.

Factory Default

To return the keypad to factory defaults, press the following icons: Setup
Advanced Setup . Enter an authorized code and select the Factory Default button. The message is
displayed:
"Warning Window"..."This Z-WAVE controller is about to be factory defaulted and will lose all devices
in the enrolled list." ... "All Z-WAVE devices must be re-enrolled after this reset."... "Each device will have to be
excluded before it can be re-enrolled."
Tuxedo reboots and reverts back to factory default settings. Note: This does not default
If Yes is selected,
any installed Z-Wave devices.
to turn On all lamp modules, dimmer On/Off
to turn Off all lamp modules, dimmer On/Off
and Advanced Setup
icon; the message is displayed:
Select Yes or No.
49
icons and enter your authorized
"Confirmation Are you sure you want
> System setup >