Honeywell TUXWIFIS Installation And Setup Manual page 13

To change the occupancy delay time, (the amount of time you want to allow for authorized entry
or exit without causing an alarm) select a time interval from the Occupancy Delay drop-down
list: choose from 15, 30, 60, 120 or 225 seconds.
When done, press Apply
The message is displayed:
Select Yes
changes."
To enter Commercial mode (automation), from the "Home" screen press the following icons: Setup
> System setup
icon; the "OPTIONS and OPERATING MODES" screen is displayed.
Highlight the Automation Mode check box to enable the option then select the Commercial check
box.
To change the occupancy delay time, select a time interval from the Occupancy Delay drop-down
list: choose from 15, 30, 60, 120 or 225 seconds.
When done, press Apply
The message is displayed: "WARNING Keypad will reset to activate changes ... Do you want to save
changes." Select Yes
Safe Mode
The Safe Mode may be automatically entered by the program on a communication failure or may be
entered manually on command.
To Exit the Safe Mode:
1. Press the ! SAFE MODE ! bar
2. Select "Yes" to return to the Normal Mode of operation. Tuxedo resets and normal operation returns
as long as the original conditions that caused the entry into Safe Mode do not still exist.
To Enter Safe Mode:
1. Select Safe Mode and then press Apply.
2. Press the OK icon.
3. To exit, press the safe mode bar and press Yes to return to Normal Mode.
While in the Safe Mode, the Home screen displays the Security, Panic, and Message Icon. A
•
message !SAFE MODE! Is displayed at the lower left side of the screen.
Tuxedo resets and restarts in the Safe Mode.
•
In the rare event that Tuxedo cannot successfully communicate in its graphic mode with the control
panel, the Safe Mode is a backup mode that ensures that you can communicate with your system.
In this mode, Tuxedo operates much like a standard non-graphic keypad so that you can control your
system until the problem is corrected.
If this situation occurs, Tuxedo presents you with a message of
and requests a
Mode?" "Yes"
First Time Setup (cont'd)
to save the settings.
"WARNING Keypad will reset to activate changes ... Do you want to save
or No
.
> CS Setup . Enter your authorized code and press the Options
to save the settings.
or No
.
! SAFE MODE !
or response. If you answer with
"No"
.
"Problems detected. Start Keypad in Safe
Tuxedo enters into the Safe
"Yes,"
13