Feed Dog Height - Janome 8050 Service Manual

feed dog HeigHt

the higheSt poSition of the feed dog ShoUld be between 0.80 and 0.90 mm from the
SUrface of the needle plate.
1. lower the preSSer foot and tUrn the power Switch on.
2. tUrn the handwheel toward yoU to Set the feed dog at the higheSt poSition.
3. remove the free-arm cover.
4. looSen the SetScrew q and nUt w.
5. adjUSt the feed dog height by tUrning the adjUSting Screw e. the higheSt poSition
of the feed dog ShoUld be between 0.80 and 0.90 from the SUrface of the needle
plate.
6. tighten the nUt w and SetScrew q.
7. attach the free-arm cover.
preSSer foot
feed dog
meCHaniCal adjustment
0.80 – 0.90mm
SUrface of the
needle plate
q
q
w
15
a b
e