Mechanical Adjustment; Presser Bar Height - Janome 8050 Service Manual

PResseR baR HeigHt

the diStance between the bottom of the preSSer foot in Up poSition and the needle
plate ShoUld be 6.0 mm.
1. remove the face plate and needle.
2. lower the feed dog below the needle plate. place a block 6 mm thick Under the
preSSer foot and lower the preSSer foot lifter w.
3. looSen the SetScrew q. raiSe the preSSer foot lifter and tighten the SetScrew q
firmly.
attach the needle and face plate.
note:
make SUre that the preSSer foot ShoUld be parallel to the feed dog SlotS e in the
needle plate.

meCHaniCal adjustment

q
6.0 mm
e
preSSer foot ShoUld
be parallel to the feed
dog SlotS.
9
w