Needle Drop Position - Janome 8050 Service Manual

needle dRoP Position

Set the Stitch pattern to "
ter of the needle plate hole q. Select zigzag Stitch "
"5.0". the clearance between the needle and the edge of the needle hole ShoUld be at
leaSt 0.2 mm on either Side. if not, adjUSt aS followS:
1. tUrn the power Switch off. remove the face cover. (See page 4.)
2. looSen the hexagonal Socket Screw 3 x 4 w. adjUSt the needle drop poSition by
tUrning the eccentric pin.
the direction of eccentric pin ShoUld be aS Shown in fig. 1.
3. attach the face cover.
note:
check the hook timing after thiS adjUStment.
w
meCHaniCal adjustment
". the Standard needle drop poSition ShoUld be at cen-
fig. 1
", and Set the Stitch width at
0.2 mm
or
more
10
q
0.2 mm
or
more
a = b