Feed Dog Height - Janome 3160QDCT Service Manual

FEED DOG HEIGHT

The highest position of the feed dog should be between 0.80 and 0.90 mm from the surface of the needle
plate.
1. Lower the presser foot and turn the power switch on.
2. Turn the handwheel toward you to set the feed dog at the highest position.
3. Remove the free arm cover.
4. Loosen the setscrew (A) and nut (B).
5. Adjust the feed dog height by turning the adjusting screw (C). The highest position of the feed dog
should be between 0.80 and 0.90 from the surface of the needle plate.
If the feed dog height is lower than 0.80 mm: turn adjusting screw (C) in the direction of (D).
If the feed dog height is higher than 0.90 mm: turn the adjusting screw (C) in the direction of (E).
6. Tighten the nut (B) and setscrew.
7. Attach the free arm cover.
Presser foot
Feed dog
MECHANICAL ADJUSTMENT
0.80 to 0.90 mm
Surface of the
needle plate
(A)
(A)
(B)
13
(E)
(D)
(C)