Mechanical Adjustment; Presser Bar Height - Janome XL601 Service Manual

Mechanical Adjustment

Presser bar height

The distance between the bottom of the presser foot in up position and the needle plate should be 6.0 mm.
1. Remove the face plate and needle.
2. Lower the feed dog below the needle plate. Place a block 6 mm thick under the presser foot and lower the
presser foot lifter w.
3. Loosen the setscrew q. Raise the presser foot lifter and tighten the setscrew q firmly.
Attach the needle and face plate.
NOTE:
Make sure that the presser foot should be parallel to the feed dog slots e in the needle plate.
q
６.０mm
Presser foot should be
parallel to the feed dog slots.
e
9
w