Set Up And Connect To The Internet; Install The Micro Sim Card - NETGEAR BigPond Wi-Fi 4G Advanced II AirCard 790S User Manual

3. Tap one of the boosting options (30, 60, or 90 minutes).

To start the jump boost of another device from the hotspot web page:
1. Plug the jump boost cable into your hotspot.
2. Plug the device you want to charge into the other end of the jump boost cable.
3. On the home page, log in as an administrator.
4. Click the Jump Boost button.
5. Select one of the boosting options (30, 60, or 90 minutes).

Set Up and Connect to the Internet

The battery and micro SIM card are pre-installed in your hotspot. If you need to re-install
these components, complete the steps in the sections listed in steps 1 and 2.

To set up and connect to the Internet:
1.

Install the Micro SIM card.

For more information, see
2. Install the battery.
For more information, see
3. Connect to the Internet.
For more information, see
4. Personalize the hotspot.
For more information, see
Install the Micro SIM Card

To insert the SIM card:
1. Remove the hotspot back cover by lifting at the notch on either corner of the device.
2. If present, remove the battery.
BigPond Wi-Fi 4G Advanced II
Install the Micro SIM Card
Install the Battery on page 13.
Connect to the Internet
Personalize the Hotspot
Get Started
12
on page 12.
on page 14.
on page 15.