Getting Started; Installing The Battery - Kyocera Angel SE47 User Manual

82-N8735-1.book Page 1 Thursday, October 27, 2005 12:37 PM
1 G S
ETTING TARTED

Installing the battery

Your Kyocera KX5 phone comes with a removable
lithium ion (LI Ion) battery.
battery before using the phone.
To install the battery:
1.
Hold the phone face
down.
2.
Slide the tab at the
bottom of the door up
and remove the
battery door.
3.
Place the battery in the
phone casing with the
metal contacts facing
the right side of the
phone.
4.
Replace the battery
door by sliding the notches into the openings
near the top of the phone.
5.
Lower the battery door
and slide the tab at the
bottom of the door up
and then down to
secure the cover
into place.
User Guide for the Kyocera Slider Remix KX5 Phone
Charging the battery
You must have at least a partial charge in the
Fully charge the
battery to make or receive calls.
To charge the battery:
1.
2.
The battery icon in the
upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Note:
phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Note:
is powered off.
Connect the AC adapter
to the jack on the
bottom of the phone.
Plug the adapter into a
wall outlet.
The battery will not charge if you use the
To remove the battery, make sure the phone
1