82-N8735-1.book Page 16 Thursday, October 27, 2005 12:37 PM
→
→
1.
Menu
Settings
Select
Digital/Analog
.
2.
Select an option and press
Automatic
–
automatically switches the
phone between digital and analog.
Analog only
–
sets the phone to work in
analog mode only.
Analog call
–
forces a call into analog mode
for the duration of the next call.
Digital only
–
sets the phone to work in
digital mode only.
Setting an alert for roaming
You may use this setting if you want the phone to
alert you when you roam outside of your home
service area.
→
→
1.
Menu
Settings
Select
Roam/Svc Alert
.
2.
Select an option and press
When no svc
–
alerts you with three tones
decreasing in pitch when service is lost
and three tones increasing in pitch when
service is acquired again.
On roam change
–
alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
16
→
Network
–
.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call will be subject to roaming charges.
• Select
Roam Ringer
Setting Call Guard
You can set the phone to warn you before you
answer or place a call while roaming.
• Select
Call Guard
– The phone now emits a distinctive roam
→
Network
.
– To accept or place a call while roaming,
Note: Call Prompt
in Emergency Mode.
On any change
alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
→
→
Menu
Settings
Sounds
→
Enabled.
→
→
Menu
Settings
Convenience
→
Call Prompt
.
ring to indicate when you are roaming
during calls.
you must press
.
is disabled when the phone is
Making and Answering Calls
→
→