2-8. CONTROL SWITCH BLOCK (FK-1800),
CONTROL SWITCH BLOCK (PS-1800)
Note: The power supply capacitor of the flash unit is charged to the high tension voltage as high as 300 V at a maximum. You will get
electrical shock when you touch the terminal of the charged capacitor. The charged potential remains even after the main power
of the machine is turned off. Discharge the remaining power in the capacitor referring to Service Note (page 8).
1 Two claws
5 Screw
PRECAUTION DURING
INSTALLATION
To attach, align the switch
position as shown.
2 Zoom cover
qf Control switch block
(FK-1800)
(M1.7 × 2.5), p
qg Tapping
qh Control switch block
(PS-1800)
Caution: High voltage
Flash unit
ROUTING OF THE HARNESS AND FLEXIBLE
AROUND THE HARNESS RETAINER.
Two harnesses must be aligned flat along this
surface and must not be overlapped.
Engage here.
7 Harness
retainer
6 Tapping
screw
(M1.7 × 5)
qa Claw
qd Tapping
screw
(M1.7 × 3.5)
screw
(M1.7 × 3.5)
0 Four tapping
screws
(M1.7 × 3.5)
Power supply
capacitor
2-9
Harness retainer
Rote the extra length this side.
qs CS frame assembly
8 Tapping
screw (M1.7 × 3.5)
9 Tapping
screw
(M1.7 × 5)
3 Two tapping
4 Grip cover
(Note)
screws
(M1.7 × 5)