Hall Adjustment; Max Gain Adjustment; Ccd Output 2Ch Matching Adjustment (1); Preparations For Ccd Output 2Ch Matching Adjustment - Sony DCR-TRV30E Service Manual

4. CCD Output 2ch Matching Adjustment (1)

4-1. Preparations for CCD Output 2ch Matching Adjustment

To perform the CCD output 2ch matching adjustment, correct the
dispersion of the iris meter.
Subject Clear chart
(Approx. 1m from the front of the lens)
(Note1)
Adjustment Page F
Adjustment Address 20 to 27
Note1: Shoot the clear chart with the zoom WIDE end. And adjust the
direction of the camera so that the chart is located in the center of
the screen.
Note2: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Note3: This adjustment should be carried out upon completion of the
following adjustments.

HALL adjustment

MAX GAIN adjustment

Note4: Turn on the camera power supply, wait for more than 3 minutes,
then perform this adjustment.
Switch setting:
1) POWER .................................................................. CAMERA
2) NIGHT SHOT .................................................................. OFF
Adjusting method:
Order Page Address Data
1 0 01 01
2 F 94
3 F 94 0A
4 6 01 BB
5 6 02
6 F 94
Note5: The adjustment data will be automatically input to page: F, address:
20 to 27.
Processing after Completing Adjustments
Order Page Address Data
1 6 01 00
2 0 01 00
3
RadarW RadarW RadarW
Procedure
Set the data.
Write down the data.
Set the data, and press PAUSE
button.
Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note5)
Set the data that is written down
at step 2, and press PAUSE button.
Procedure
Set the data, and press PAUSE
button.
Set the data.
Perform "CCD Output 2ch
Matching Adjustment (1)".
4-2. CCD Output 2ch Matching Adjustment (1)
Correct the dispersion of the black level between the left-right
channels of the CCD imager.
Subject
Adjustment Page
Adjustment Address
Note1: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Note2: This adjustment should be carried out upon completion of the
following adjustments.
HALL adjustment
MAX GAIN adjustment
Preparations for CCD output 2ch matching adjustment
Note3: Turn on the camera power supply, wait for more than 3 minutes,
then perform this adjustment.
Switch setting:
1) POWER .................................................................. CAMERA
2) NIGHT SHOT .................................................................. OFF
Adjusting method:
Order Page Address Data
1 0 01
2 6 01
3 6 02
Note4: The adjustment data will be automatically input to page: F, address:
7C, 7D.
Processing after Completing Adjustments
Order Page Address Data
1 6 01
2 0 01
3
5-19
All black
(Cover the lens with the black cap)
F
7C, 7D
Procedure
01 Set the data.
73 Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note4)
Procedure
00 Set the data, and press PAUSE
button.
00 Set the data.
Perform "CCD Output 2ch
Matching Adjustment (2)".