BT EDGE 2500 User Manual page 62

BT Edge 2500 – Issue 2 – Edition 1 – 25.08.05 – 7032
62 Help
Cannot dial out or receive calls
Check that the mains power is correctly connected.
The batteries may need recharging.
Has there been a power cut? If so, place the handset
back on the base for 10 seconds and try again. If it still
does not work disconnect the batteries and mains power
for 10 minutes, then reconnect and try again.
You have a dial tone, but the phone will not dial out
You may need to change the dial mode from tone to
pulse, see page 26.
If you are connected to a switchboard, check whether
you need to dial an access code.
Handset does not ring
The ringer volume may be switched off, see page 29.
Check that the mains power is correctly connected.
Make sure the handset is registered to the base, see
page 57.
No display
The batteries may be flat, dead or incorrectly inserted.
Recharge or replace the batteries.