Using The Level Adjust Function - Sony HDVF-EL75 Operation Manual

Hd electronic viewfinder

Hide thumbs Also See for HDVF-EL75:

Service manual (72 pages)

Table Of Contents

Table of Contents

MODE1: Standard magnified display

MODE2: Displays the original image at the bottom

right corner of the magnified image

MODE3: Displays the magnified image at the center

of the original image

To return to normal display

The two manners of returning to the normal display,

under "AUTO RELEASE" settings in the

MAGNIFICATION menu, are as follows.

"AUTO": Returns to the normal display automatically in

a specified time after magnifying the image using the

ASSIGN. switch.

"MANUAL": Press the ASSIGN. switch again to return

to the normal display.

Using the Level Adjust

Function

For details on menu operations, see "Using the Menu"

on page 44.

This function can be used to display the output level of the

camera after adjustment inside the unit.

Notes

• The output level of camera cannot be adjusted. This

function has no effect on the camera's output signals.

• Set the camera not to display the characters or the

markers before executing "AUTO SETUP."

Input the built-in color bar signal of camera to the

viewfinder.

The viewfinder can display the color bars below.

• 75% full field color bar

• 100-75% full field color bar

• 100% full field color bar

• SMPTE color bar

For details about the built-in color bar, refer to the

manual for the camera.

Select the color bar to display in the viewfinder under

"COLOR BARS" of the LEVEL ADJUST menu.

The viewfinder recognizes the type of color bar input

from the camera automatically when "AUTO" is

selected.

To set the color bar manually, select one of the color

bars below.

75-75: 75% full field color bar

100-75: 100-75% full field color bar

100: 100% full field color bar

SMPTE: SMPTE color bar

Select "AUTO" under "AUTO ADJUST" of the

LEVEL ADJUST menu.

Select "EXEC" under "AUTO SETUP" of the

LEVEL ADJUST menu.

Select "YES."

The setting is executed. Select "NO" to cancel.

"COMPLETE" is displayed when setting is finished.

"ERROR" is displayed if a setting is not finished

completely. In this case, input the color bar correctly

from step 3.