The User - HP ProLiant Gen9 Troubleshooting Manual

Action: Power down the server and put these switches in the OFF position (SW1 in the ON position disables
iLO Security).
253- IMPORTANT: The PCI-e Device installed in Slot X has no corresponding
processor installed and will not function
Action: Move the PCI-e Device to another slot or install Processor Y.
256- IMPORTANT: A PCI-e Riser Card is installed that requires 2 processors to
function
...Slots on this riser are unusable with the current configuration.
Action: Install a second processor to use this riser.
262- Redundant ROM Error: The Backup System ROM is invalid
...The system is operating on the Primary System ROM.
Action: No action required, but flashing the System ROM will restore System ROM redundancy.
263- Redundant ROM Error: The Primary System ROM is invalid
...The system is operating on the Backup System ROM.
Action: Flash the System ROM to the preferred revision to restore System ROM redundancy.
264- Fatal System ROM Error: The System ROM is not programmed properly
...System halted.
Action: Replace the System ROM part.
265- Fatal System ROM Error: The programming of the System ROM cannot be
verified
Action: Reset iLO and cold boot the system.
266- Non-Volatile Memory Corruption Detected
...Configuration settings restored to defaults. If enabled, Secure Boot security settings may be lost.
Action: Restore desired configuration settings. Contact HP if issue persists.
267- IMPORTANT: Default configuration settings have been restored at the request of

the user

Action: Restore any desired configuration settings which differ from defaults.
268- iLO FW Not Responding – Unable to communicate with iLO FW
...Certain management functionality is not available.
Action: Remove power. If issue persists, update iLO FW. If issue still persists, contact HP service.
HP ProLiant server errors 59