Hp Ilo Errors; Ilo Overview; Ilo Post Led Indicators; Event Log Entries - HP ProLiant Gen9 Troubleshooting Manual

HP iLO errors

iLO overview

This section provides information about iLO error messages. For the latest information on iLO error messages,
go to the HP website (http://www.hp.com/go/ilo) to download the latest iLO user guide.

iLO POST LED indicators

During the initial boot of iLO, the POST LED indicators flash to display the progress through the iLO boot
process. After the boot process is complete, the HB LED flashes in one second intervals. LED indicators (1
through 6) illuminate after the system has booted to indicate a hardware failure. If a hardware failure is
detected, reset iLO. For the location of the LED indicators, see the server documentation.
A runtime failure of iLO is indicated by HB constantly remaining in either the On or Off state. A runtime failure
of iLO can also be indicated by a repeated flashing pattern on all eight LEDs. If a runtime error occurs, reset
iLO.
The LED indicators have the following assignments.
HB
LED indicator
None
2
HB and 2
5,4,3,2,1 and blinking 0F
HB, 7, and 6 steady
5,4,3,2,1 blinking
HB

Event log entries

Event log display
Server power removed
Browser login: IP address
7 6
POST code (activity
completed)
00
02 - Normal operation
82
E0
—
5 4
Description
Set up chip selects
Scrub done
Kernel launch
Main error - recovery
Kernel error
Flashes as the iLO
processor executes firmware
code. It does not change the
value of the lower seven
LEDs.
Event log explanation
Displays when the server power is removed.
Displays the IP address for the browser that logged in.
3 2
Failure indicated
—
—
Subsystem startup failed if this
status remains for extended
period of time (~60 seconds)
The main payload is corrupt;
the kernel is running flash
recovery.
Failure to find and load a
kernel
—
1
HP iLO errors 235