Log Placement; Charcoal Embers; Vermiculite - Napoleon Vittoria GD19N Installation And Operating Instructions Manual

7.3

LOG PLACEMENT

LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
In order to assemble the log set, the glass door must be removed, see "GLASS DOOR INSTALLATION AND
REMOVAL"section.
7.3.1 Place the rear log as shown, ensuring the
holes on the underside are placed onto the 2
pins of the log support.
7.3.3 Place the center log as shown, ensuring the
holes on the underside are placed onto the
two centre pins.
7.4

CHARCOAL EMBERS

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
7.5

VERMICULITE

Sprinkle vermiculite around the charcoal embers.
NOTE: Vermiculite is not to be placed on the burner.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
BRACKET
WARNING
!
7.3.2 Place the left log as shown, ensuring the hole
on the underside is placed onto the burner
pin. This will rest on the left side of the rear
log.
7.3.4 Place the hole in the underside of the right log
onto the locating pin, on the burner base and
rests against the rear log as shown.
7.3.5 Re-install the glass door.
39
32.1
33.1
W415-0825 / 07.06.09