Code Approval - Majestic DVDNV series Operating Instructions Manual

Designer series direct vent
Table of Contents

Advertisement

Designer Series Gas Fireplaces
14. Do not use any solid fuels (wood, coal, paper, card-
board, etc.) in this fireplace. Use only the gas type
indicated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
17. When the appliance is installed directly on carpeting,
tile or other combustible material other than wood
flooring, you must set appliance on a metal or wood
panel or hearth pad extending the full width and depth
of the appliance.
18. Do not use fireplace if any part has been exposed to
or under water. Immediately call a qualified service
person to arrange for replacement of the unit.
19. Do not operate fireplace if any log is broken.
0. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
1. Do not operate the fireplace with glass door removed,
cracked, or broken.
. This unit is approved for bedrooms and bathrooms.
WARNING
!

CoDE aPPRoVaL

Direct Vent type appliances draw all combustion air from outside of the dwelling through the
AVERTISSEMENT
vent pipe.
!
These appliances have been tested by CSA and found to comply with the established standards for
DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
Tested To: ANSI Z1.88-009 / CSA .33-009 Standards
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufac-
tured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard
is not applicable, the Standard for Manufactured home Installations, aNSI/NCSBCS a225.1, or
Standard for Gas Equipped Recreational Vehicles and Mobile housing, CSa Z240.4.
4
IMPoRTaNT SaFETy INFoRMaTIoN and CoDE aPPRoVaL
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
Listed Vented Gas Fireplace heater
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
IMPoRTaNT:
PLEaSE REaD ThE FoLLowING
CaREFuLLy
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found
with your furnace heat exchanger or car engine.
IMPoRTaNT:
PLEaSE REaD ThE FoLLowING
CaREFuLLy
It is not unusual for gas fireplaces to give off some
odor the first time it is burned. This is due to the
manufacturing process.
Please ensure that your room is well ventilated
during burn off — open all windows.
It is recommended that you burn your fireplace for at
least ten (10) hours the first time you use it. Place the
fan switch in the "OFF" position during this time.
Never connect unit to private (non-
utility) gas wells. This gas is commonly
known as wellhead gas.
53D0419

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dne seriesDpe seriesDpv series

Table of Contents