Watching Television - KVH Industries TracVision L3 Owner's Manual

Kvh industries satellitetelevision owner's manual tracvision l3, tracvision s3
Hide thumbs Also See for TracVision L3:
Table of Contents

Advertisement

2. Open the terminal emulation software and
establish the following settings:
• 9600 baud
• no parity
• 8 data bits
• 1 start bit
• 1 stop bit
• no flow control
3. Once the data connection is made, enter the
Satellite Selection command as follows:
Command:
Where:
To select Satellite A, you would enter @L,A<cr> .
To select Satellite B, you would enter @L,B<cr> .
4. The antenna unit shifts to track the second
satellite.
3.3

Watching Television

TracVision L3 is designed to operate whether your vehicle is in
motion or parked. TracVision S3 is designed to operate only
while your vehicle is parked.
Using Your TracVision L3/S3 When Parked
When your vehicle is stopped, it is not necessary for the
TracVision L3/S3 to be turned on. After parking your vehicle and
confirming that the antenna is receiving the satellite signal, you
may turn off the TracVision L3/S3 unit to avoid unnecessary use
of power. Because the LNB receives its power from the IRD, the
antenna will continue to receive the satellite TV signals and relay
them to the IRD.
However, if you plan to change to a channel that is broadcast by
another satellite, TracVision L3/S3 must be turned on so the
antenna can search for, identify, and lock onto the different
satellite.
54-0157 Rev. G
@L,x<cr>
(<cr> indicates a carriage return/ENTER key)
x = A or B (whichever satellite you want to
track)
Using Your TracVision L3/S3
(TracVision L3 only) Don't forget to
turn the system back on before you
start driving again. The antenna
must be turned on to track the
satellite while you are moving.
3-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tracvision s3

Table of Contents