Control Compass Mode - KVH Industries TracVision G4 Technical Manual

3.6

Control Compass Mode

These screens are only seen if heading reference is INTERNAL.
The Control Compass function provides control over the
GyroTrac sensor module, including turning autocalibration on
and off, reading the calibration score, and manually clearing the
compass calibration.
Control Compass?
Enter Next Return
ALERT SCREENS
Set Autocal on/off?
Yes Next Return
Selecting Autocalibration
These screens are only seen if heading reference is INTERNAL.
GyroTrac is fully capable of autocalibration to ensure that the
navigation data is as accurate as possible.
Set AutoCal On/Off?
Yes Next
AutoCal is: ON
ON ENTER
54-0147
Read cal score?
Yes Next
Return
Proceed to "Reading the
Calibration Score"
OFF
Autocalibration setting will blink "ON" or
"OFF" based on current selection.
Pushing the ON or OFF buttons will
change the selected setting.
Figure 3-21
Compass Control Mode
Menu Sequence
Clear COMPASS cal?
Return Yes Next
Figure 3-22
Setting Autocalibration
A well-calibrated sensor is crucial
to GyroTrac's accuracy. If you shift,
remove, or add equipment near the
sensor, KVH suggests turning
autocalibration on so that the
sensor will automatically recalibrate
itself.
Using the ADCU Interface
Return
77