KVH Industries TracVision G4 Technical Manual page 50

Installing Your Selected Satellites
To install your selected satellites as Satellite A and B, follow the
steps below.
1. Apply power to the ADCU.
2. Following the startup sequence, press the center
button until the "Control Antenna?" screen
appears.
Enter
3. Press the ENTER button to access the Control
Antenna Mode.
4. Press the center button until the "Install Satellite?"
screen appears.
Yes
5. Follow the process shown in Figure 2-35 on the
following page to install your selected satellites. At
the end of the process, be sure to press the YES
button to restart the antenna.
54-0147
Control antenna?
Next Return
Install satellite?
Next Return
Figure 2-33
Control Antenna Screen
Figure 2-34
Install Satellite Screen
Section 3, "Using the ADCU
Interface" on page 59 provides
complete details on the use of the
ADCU menus, including complete
antenna control details in
Section 3.8, "Control Antenna
Mode" on page 81.
Installation
45