FUNAI WD6D-M100 Service Manual page 36

FLOW CHART NO.3
Cassette tape can not be loaded.
When loading a cassette tape, on Pin(100) of IC501,
does the "L" pulse switch to the "H" pulse?
When loading a cassette tape, is the specified voltage
(approximately 13V) outputted to the terminal of the
Loading Motor Unit?
Replace the Loading Motor Unit.
FLOW CHART NO.4
Cassette tape is ejected right after the loading.
When loading a cassette tape, on Pin(100) of IC501,
does the "L" pulse switch to the "H" pulse?
When loading a cassette tape, on Pin(4) of IC501,
does the "L" pulse switch to the "H" pulse?
When loading a cassette tape, does the LD-SW
operate normally?
Replace IC501.
FLOW CHART NO.5
Cassette tape can not be ejected.
When pressing the eject button, does the Capstan
Motor start rotating?
While the Capstan Motor is rotating, is the Takeup
Reel rotating?
While the Takeup Reel is rotating, is the reel pulse
signal inputted to Pin(80) of IC501?
While the reel pulse signal is inputting, is "L" pulse
outputted to Pin(81) of IC501?
Is the specified voltage (approximately 13V)
outputted to the terminal of the Loading Motor Unit?
Is the Loading Motor rotating?
Check the Cam Gear or Rack Assembly, etc.,
and service it if defective.
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Check the line between the start sensor and Pin(100)
No
of IC501, and service it if defective.
No
Replace the Capstan Motor Unit.
Check the line between the start sensor and Pin(100)
No
of IC501, and service it if defective.
No
Check the line between the end sensor and Pin(4)
of IC501, and service it if defective.
No
Check the line between the LD-SW(SW507) and Pin(9)
of IC501, and service it if defective.
No Refer to "FLOW CHART NO.6 " <The Capstan Motor
does not rotate>.
No
Check the Reel Disc or Clutch Assembly, and service
it if defective.
No
Check the line between the Takeup Reel sensor and
Pin(80) of IC501, and service it if defective.
No
Replace IC501.
No
Replace the Capstan Motor.
No
Replace the Loading Motor.
1-11-12 E9TFCTR