FUNAI WD6D-M100 Service Manual page 24

Message
Disc is full.
(No area for new recording)
You cannot record more than
99 titles on one disc.
(The maximum is 99.)
You cannot record more than
999 chapters on one disc.
(The maximum is 999.)
You cannot record on this disc
as Control Information is full.
You cannot record on the disc
as Power Calibration Area is
full.
This disc is already finalized.
Can not record on this disc.
This program is not recordable
in +VR mode.
This Program is not allowed to
be recorded.
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error
messages (error number: 1 to 39, 45 and 51) is displayed on the recording menu after timer recording.
(Once the screen of the program line is exited, the program line for the error will be cleared.)
(No Error Message is displayed for the error No. 40 ~ 42.)
Message
Error message is not
displayed.
Solution
Insert the recordable disc with
enough recording space.
Delete unnecessary titles.
Delete unnecessary chapters.
Insert a new disc.
Insert a new disc.
Release the finalizing for this
disc.
Repeat the same operation.
You cannot record copy-
prohibited programs.
Receive PAL/SECAM signal.
Error number
A program with the error number is grayed out on the timer programming list.
Solution
- Set the timer programming
correctly.
- Set the timer programming
before the start time.
- Insert a recordable videotape
with a record tab.
Turn the power on and set the
clock correctly then set timer
programming again.
Insert the recordable disc.
Error
No.
30 No available recording space.
The 99 title limit has been reached.
31
(Video Format Disc)
The 99 title limit has been reached. (VR
32
Format Disc)
The 999 chapter limit has been reached.
33
(VR Format Disc)
No available recording space for Control
34
Information.
35 PCA is Full. (in REC start)
36 It is finalized. (Video Format Disc)
37 Access to Memory Area range outside.
38 Sector Address is wrong.
39 BUP writing error of chapter editing.
During the CGMS picture input (+VR
45
Format Disc).
When you receive signal other than PAL/
51
SECAM.
Error
No.
- Some portion has not been recorded
because of program overlapping.
40 - Recording did not start at the start time.
- No Videotape is inserted.
Videotape ran out during recording.
41 Power failed
42 No disc when recording
1-10-3
Error Description
Error Description
E9TF0FIS