Reference Notes - FUNAI WD6D-M100 Service Manual

Reference Notes

1. Locking Tabs (L-1) and (L-2) are fragile. Be careful
not to break them.
1-1. Remove Screw (S-2).
1-2. Release four Locking Tabs (L-1).
1-3. Release three Locking Tabs (L-2).
1-4. Disconnect Connector (CN6001), and
remove the Front Assembly.
2. The DVD Mechanism & DVD Main CBA
Assembly is adjusted as a unit at factory.
Therefore, do not disassemble it. Replace the
DVD Mechanism & DVD Main CBA Assembly
as a unit.
3. When reassembling, solder wire jumpers as
shown in Fig. D7.
4. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on the AV CBA as shown
in Fig. D7. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D7.
5. When reassembling, be sure to use the original
screws or specified screws listed in the parts
list.
[1] Top Cover
(S-1)
(S-1)
(S-1)
(S-1)
Fig. D1
1-6-2
(S-4)
(S-4)
Front
Support
(S-4)
(L-1)
(S-2)
(L-2)
CN981
CN701
CN101
(S-9)
CN901
[5] *DVD
Mechanism
& DVD Main
CBA Assembly
Dust
Cover
* See Reference Note 2.
[4] Front Bracket
(S-5)
(S-3)
CN6001
(L-1)
[3] USB
CBA
USB Holder
USB Earth Plate
[2] Front Assembly
Fig. D2
Mecha Earth
(S-7) Plate
CN502
(S-7)
(S-8)
Hook
(S-6)
Fig. D3
E9TFCDC