Exchanging The Headlight Lamp (Lc4 Supermoto); Replacing The Parking-Light Bulb (Lc4 Supermoto); Adjusting The Headlight Range (Lc4 Supermoto) - KTM ENDURO 640 LC4 Owner's Manual

»
MAINTENANCE WORK ON CHASSIS AND ENGINE

Exchanging the headlight lamp (LC4 Supermoto)

Removing the headlight mask:
Remove the left and right screws [1] and the speedometer cover.
Detach the headlight mask and tilt towards the front.
Replacing the headlight lamp:
Pull the plug [2] off the bulb
Remove the rubber cap [3]
1
1
Turn the lamp base [4] approx. 30° in a counterclockwise direction and pull
out of the socket.
When inserting the new bulb [5] make sure that it fits correctly in the socket.
NEVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS. THE GLASS OF
THE BULB MUST REMAIN ABSOLUTELY FREE FROM GREASE. HEAT WILL OTHER-
WISE CAUSE THE GREASE TO EVAPORATE AND SETTLE DOWN ON THE
REFLECTOR.
3
To mount, proceed in the reverse order.
Mounting the headlight mask:
Fit the headlight mask in the respective brackets.
Mount the speedometer cover and screws [1].
2
6
36

Replacing the parking-light bulb (LC4 Supermoto)

Disassemble the headlight as described above and simply pull the bulb socket
4 [6] out of the reflector.
5

Adjusting the headlight range (LC4 Supermoto)

The payload can make it necessary to correct the headlight range.
The headlight range can be adjusted with the adjusting screw [7]. Turning in
a clockwise direction will reduce the headlight range, turning in a counter-
clockwise direction will increase the headlight range.
7
TO CHECK:
Determine the distance from the ground to the center of the headlight when
your motorcycle is loaded and ready for the trip (baggage, driver, passenger).
Make a mark on a light wall behind a level surface at a height corresponding
5 m
to the center of the headlight. Position your motorcycle loaded ready for the
trip 5 meters (16,4 ft) away from the wall and switch on the low beam. The
light/dark cut-off line should be 5 cm (2 in) under the mark (see
drawing).
5 cm
x