Exchanging The Brake Light And Tail Light Bulb (Lc4 Supermoto); Exchanging The Headlight Lamp (Lc4 Enduro); Replacing The Parking-Light Bulb (Lc4 Enduro) - KTM ENDURO 640 LC4 Owner's Manual

»
MAINTENANCE WORK ON CHASSIS AND ENGINE

Exchanging the brake light and tail light bulb (LC4 Supermoto)

Remove seat.
Disengage retaining clip [1] and take bulb out of reflector. When changing
the brake-light lamp, simply pull it out of the holder.
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it out
of the socket.
To mount the lamp reverse the worksteps indicated above.
2
When changing the tail-light lamp [2], simply pull it out of the holder.
2
1
35

Exchanging the headlight lamp (LC4 Enduro)

Replacing the headlight bulb
Remove the headlight mask:
Remove screw [3] on the left and right.
Tilt the headlight mask to the front and detach from the lower fender.
Exchanging the headlight lamp:
3
Disconnect plug [4] from the bulb.
Remove the rubber cap [5]
Unhook the retaining bracket, then remove the bulb.
When inserting the new bulb make sure that the wider of the 3 tongues [6]
is located in the corresponding groove in the socket.
NEVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS. THE GLASS OF
THE BULB MUST REMAIN ABSOLUTELY FREE FROM GREASE. HEAT WILL OTHER-
WISE CAUSE THE GREASE TO EVAPORATE AND SETTLE DOWN ON THE
REFLECTOR.
Hook in the retaining bracket, mount the rubber cap and connect the plug to
the bulb.
4
Mount the headlight mask:
Position the headlight mask such that the headlight is located under the cock-
pit.
Fit the headlight mask into the fender and mount screws [3].
5
7

Replacing the parking-light bulb (LC4 Enduro)

Disassemble the headlight as described above and simply pull the bulb socket
[7] out of the reflector.
6