Fuses; Exchanging The Brake Light And Tail Light Bulb (Lc4 Enduro) - KTM ENDURO 640 LC4 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
A
Enduro
34
Supermoto
A

Fuses

Fuse box [A] is located under the seat.
See "Removing the seat" to remove and mount the seat.
The fuses are numbered on the inside of the fuse box.
The fuses marked "RES" are spare fuses.
FUSE
1
2
3
4
5
Replace a blown fuse only with an equivalent one. If a new fuse that has just
been set in gets blown again, you are strongly advised to have it inspected by
a KTM dealer.
UNDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR
A FUSE ALLOWED TO BE "REPAIRED". AN INEXPERT TREATMENT COULD DAM-
AGE THE WHOLE ELECTRICAL INSTALLATION!

Exchanging the brake light and tail light bulb (LC4 Enduro)

Remove the cap [1] on the underside of the license plate retainer.
1
Turn the lamp socket [2] approximately 30° counterclockwise and pull it out
of the tail light housing.
2
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it out
of the socket.
To mount the lamp reverse the worksteps indicated above.
NOTE: Since the bulb on the tail end is subjected to higher vibrations, heavy-
duty bulbs are available from your KTM dealer.
»
LC4 SUPERMOTO
10 Ampere
– electronic speedometer
– capacitor
10 Ampere
– ignition
– starter system
10 Ampere
– flasher lights
– brake light
– horn
10 Ampere
– headlight
– parking light
–
LC4 ENDURO
20 Ampere
protects all power consumers
against short circuits.
10 Ampere
– electronic speedometer
– capacitor
10 Ampere
– ignition
– starter system
10 Ampere
– flasher lights
– brake light
– horn
10 Ampere
– headlight
– parking light