Load Lever Assembly; Bt Lever Assembly - Sony SLV-L45AR Service Manual

QQ
3 7 63 1515 0
3-10.L GUIDE LEVER ASSEMBLY AND

LOAD LEVER ASSEMBLY

(See Figs. 3-10-1 )
1) Refer to section 3-3 and remove the cassette mecha-
nism assembly.
2) Refer to sections 3-9-1 and 3-9-2, then remove the
pinch roller lever assembly and the opener mounting.
3) After removing the washer 4, remove the L guide act
lever assembly 5.
4) Remove the special nut 6, then remove the load lever
assembly 7 and the L guide lever spring 8.
ASSEMBLY NOTES:
1) Apply grease (SGL-505) to the toothed area A of the L
guide act lever assembly 5 and around the shafts 9
and 0.
2) Refer to section 4-3 and adjust the height of the load
lever assembly.
3) Hook the L guide lever spring 8 into the stopper !£
and load lever assembly 7 shown in Fig. A.
4) Put the pin !¡ of the L guide act lever assembly into the
cam groove !™ of the crescent slide.
6 Special nut
7 Load lever
assembly
TE
L 13942296513
8 L guide lever spring
4 Washer
5 L guide
A
act lever
assembly
!¡ Pin
0 Shaft
!™ Cam groove
www
.
http://www.xiaoyu163.com
8 L guide lever spring
Fig. A
7 Load lever assembly
9 Shaft
!£ Stopper
Fig.3-10-1
x ao
y
i
http://www.xiaoyu163.com
8

3-11. BT LEVER ASSEMBLY

(See Fig. 3-11-1 )
1) Refer to section 3-2 and remove the mechanism unit.
2) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
3) Remove the BT spring 1.
4) Remove the clamp 2 on the underside of the mecha-
nism chassis, then remove the BT lever assembly 3.
5) Remove the clamp 5 on the band brake assembly 4.
Then, as shown in Fig. A, align the other end of the
band brake assembly with the protruding parts of the
BT lever assembly 3 before removing it.
ASSEMBLY NOTES:
1. When fitting the BT lever assembly 3, be careful not to
bend the stopper 6 or the S incline mounting assembly
7 out of shape by knocking it against them.
2. Hook the long hook of the BT spring 1 into the BT
Iever assembly 3, as shown in Fig. B.
3. After assembly. make sure that the mountings on both
ends of the band brake assembly 4 are positioned as
shown in Fig. C.
4. After assembly, refer to section 4-2-1, and make the
appropriate adjustment.
5 Clamp
Fig. A
Q Q
3 6 7 1 3
Protruding
Fig. B
parts
1 BT spring
u163
.
5-16
2 9 9 4 2 8
4 Band brake
assembly
3 BT lever
1 5 0 5 8 2 9 9 4
Fig. C
6 Stopper
2 Clamp
Fig. 3-11-1
m
co
9 9
assembly
2 8 9 9
7 S incline
mounting
assembly