Table of Contents
Advertisement
QQ
3 7 63 1515 0
3-16.CRESCENT SLIDE
(See Figs. 3-16-1 and 3-16-2)
1) Refer to section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
2) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
3) Refer to section 3-7-2 and remove the capstan brake
assembly.
4) Refer to section 3-12-4 and remove the T soft brake
assembly.
5) Refer to section 3-13-1 and remove the T brake act
slide.
6) Refer to section 3-12-1, then remove the reel belt and
the reel pulley.
7) Refer to section 3-15, then remove the wheel gear 2
and the main cam.
8) Refer to section 3-13-2, then remove the wheel gear 1
and the brake control lever.
9) Remove the two screws !¡, then remove the crescent
mounting !™.
10) Remove the clamps 1 and 2, then raise the right end
of the crescent slide 3 slightly. Slide the crescent slide
3 to the right until it comes away from the clamp 4,
then remove it.
ASSEMBLY NOTES:
1. Apply grease (SGL-505) to the points A, B, C and D
in Fig. 3-16-1, and to the crescent slide 3 shown in
Fig. 3-16-2.
2. Before fitting the crescent slide 3, refer to section 3-13-
TE
L 13942296513
3 and align the arrow on the S brake act slide with the
arrow on the mechanism chassis. Then refer to Fig. 3-
17-3 and check that the S load gear and the T load gear
have completed tape unloading.
3. When assembling the parts, raise the right side of the
crescent slide 3 slightly, and keeping it in this position,
slot the left side into the clamp 4, then align the hole
5 with the hole 6 in the mechanism chassis. When
you do this, check that the hole 7 is aligned with the
pin 8 on the BT spring lever assembly, and that the
hole 9 is aligned with the pin 0 on the S brake act
slide, before pressing the crescent slide 3 into place.
Check that the clamps 1, 2 and 4 are engaged.
4. After assembly, check that each leverand each brake is
working properly.
www
.
http://www.xiaoyu163.com
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
3 Crescent slide
5 Hole
1 Clamp
2 Clamp
A
6 Hole
4 Clamp
Apply grease to the areas shown in
• The places marked by dots should be greased
particularly generously.
Q Q
3
6 7
1 3
1 5
Grease the sides
Grease the teeth
co
.
5-22
9 4
2 8
!¡ Screw
!™ Crescent
mounting
7 Hole
9 Hole
D
8 Pin
0 Pin
Fig. 3-16-1
0 5
8
2 9
9 4
2 8
Crescent
slide
Fig. 3-16-2
m
9 9
9 9
Advertisement
Table of Contents
