Table of Contents
Advertisement
QQ
3 7 63 1515 0
3-2. MECHANISM UNIT
(See Figs. 3-2-1 and 3-2-2)
1) Remove the top cover, bottom cover and front cabinet
assembly.
2) Unplug the flat cable 1 from the VM-1/VP-1 PWB
assembly on the cylinder (drum), and unplug the ACE
head connector 3.
3) Remove the screw 2, the two screws 4, then remove
the VM-1/VP-1 PWB assembly 5, lifting it upwards.
The shape of the VM-1/VP-1 PWB assembly and the
bracket varies according to the model.
4) Remove the four screws 6 and the two screws 0, then
lift up the mechanism unit. The tray 7 will stop you
removing the two screws 6 on the front, so release the
lock by pressing down the tray lock lever 8 and the lid
opener lever 9 shown in Fig. 3-2-2, then slide off the
tray 7. Move the tray by referring to section 3-1 and
turn the loading motor in the PLAY direction.
6 Screw
7 Tray
TE
L 13942296513
3 ACE head
connector
0 Screw
8 Tray lock
lever
www
7 Tray
.
http://www.xiaoyu163.com
1 Flat cable
Bracket
6 Screw
6 Screw
4 Screw
2 Screw
VM-1 (VP-1)
PWB
assembly
Fig.3-2-1
9 Lid opener
lever
x
ao
y
i
Fig.3-2-2
http://www.xiaoyu163.com
8
3-3.CASSETTE DRIVE MECHANISM
3-3-1 . CASSETTE MECHANISM ASSEMBLY
(See Figs.3-3-1 and 3-3-2)
1) Put the VCR into EJECT mode.
2) Remove the two screws 1.
3) Lift up the back of the cassette mechanism assembly 2
slightly, and remove the two hooks 3 on the front.
ASSEMBLY NOTES:
1. The cassette mechanism assembly and the mechanism
chassis should both be fitted in EJECT mode.
2. Check that the two hooks 3 have snapped into the
mechanism chassis, and make sure that the two holes
4 in the cassette mechanism assembly are aligned
with the two dowels 5 on the mechanism chassis.
3. Make sure that the big tooth on the pinion gear of the
cassette mechanism assembly slots properly into the
deepest gap in the start rack gear, as shown in Fig. 3-3-
2.
4. When fitting the two screws 1, use the torque gauge
screwdriver (J-6082-047-A). Give the screws a tighten-
ing torque of 5 kg/cm.
Q Q
3
6 7
1 3
3 Hook
5
Dowel
4 Hole
Ensure correct
interlocking
Drive gear
Lock gear
u163
.
5-8
2 9
9 4
2 8
1 Screws
2 Cassette mechanism assembly
1 Screws
1 5
0 5
8
2 9
9 4
Mechanism
chassis
3 Hook
4 Hole
Pinion gear
Ensure correct
interlocking
m
Start rack gear
co
Fig. 3-3-2
9 9
2 8
9 9
Fig.3-3-1
Advertisement
Table of Contents
