Personalizing The Projector Menu Display; Shutting Down The Projector - BenQ W700 User Manual

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the
length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
frame.
• Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD
menus. Use
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use

Shutting down the projector

1. To turn the projector off, press POWER
OFF on the remote control to turn
projector off directly. Or you can press
warning message appears. 
Press
2. Once the cooling process finishes, the
POWER indicator light is a steady
orange and fans stop.
3. Disconnect the power cord from the
wall socket if the projector will not be
used in an extended period of time.
• To protect the lamp, the projector will not
respond to any commands during the
cooling process.
• To shorten the cooling time, you can also
activate the Quick Cooling function. See
"Quick Cooling" on page 51
• If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press POWER again to start
the projector after the fans stop and the POWER indicator light turns orange.
• Lamp life results will vary depending on environmental conditions, and usage.
Downloaded From projector-manual.com BenQ Manuals
/ to select your language.
POWER on the projector and a
POWER again.
for details.
/ to select a preferred position.
/ to select a screen.
/ to select a suitable time
Operation 45