Table of Contents
Advertisement
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for
the OSD menus. Press MODE/ENTER to display language page. Use
and MODE/ENTER to select your language.
•
Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu
sets the length of time the OSD will remain active after your last key press. The
time length ranges from 5 to 30 seconds in 5-second increments. Use
select a suitable time frame.
•
Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets
the OSD position in five locations. Use
•
Reminder Message in the SYSTEM SETUP: Basic > Menu Settings menu
sets whether to display reminder messages on screen. Use
desired setting.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo
screen to be displayed during projector start-up. Use
Select the Light Mode
•
Using the remote control.
Press LAMP MODE and the light mode selection bar
appears. Use
Dimming.
•
Using the OSD menu.
1.
Press MENU/EXIT and then press
SYSTEM SETUP: Advanced menu is selected.
2.
Press
ENTER. The Light Settings page displays.
3.
Select Light Mode and press
Economic/Dimming. The light brightness vary from the
different light mode, see the description list in table below.
Light Mode
Normal
Economic
Dimming
If the Economic mode or Dimming mode is selected, the light output will be
reduced and result in darker projected pictures.
Operation
40
/
to select Normal/Economic/
to select Light Settings and press MODE/
Description
Provides full light brightness
Lowers brightness to extend the light source life and
decreases the fan noise
Lowers brightness to offer a longer light source life.
/
to select a preferred position.
/
until the
/
to select Normal/
/
/
/
to select your
/
to select a screen.
/
/
to
Advertisement
Table of Contents
