Compaq ProLiant DL380 Quick Install Manual page 45

3-6 Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
25. Create a firmware diskette at this time if you are completing this step on
node 1. You will use this diskette later to upgrade the RA4000 controller
firmware. If you are performing this procedure on node 2, skip this step
and continue with the following section "Updating Controller
Firmware."
To create a firmware diskette, obtain one DOS formatted diskette, and
follow these steps:
a. Click Create Support Software.
b. Click the plus sign (
c. Page down to
Options ROMPaq,
the onscreen instructions indicate that you need 10 diskettes, this
procedure creates only a single diskette. A screen for creating the
first diskette displays.
d. Click Skip. The
displays.
e. Insert the formatted diskette into the disk drive, and then click OK.
f. Wait for the software to be written to the diskette.
g. Remove the diskette from the drive after the software has been
written to the diskette.
h. Click Skip on each of the remaining screens, and then click Finish
at the final screen to return to the
window.
26. Remove the SmartStart CD and power down the node.
27. Repeat the procedures for erasing a configuration (if necessary) and
configuring servers on node 2. Do not repeat step 25 on node 2.
If you have erased any existing configuration on both nodes of your server and
have configured both nodes with SmartStart, continue with the following
section, "Updating Controller Firmware," to upgrade controller firmware.
) next to .
+ Compaq
select it, and then click Next. Although
Firmware Upgrade diskette for the RA4000 Controller
Compaq SmartStart-Manual Path