Save; Software Clone - Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER Owner's Reference Manual

4.
Press the enter button or key to confirm the selection. The front panel display
reads:
RS-232 CONTROL.
The right-terminated preamplifier channel is the link transmitter of RS-232 data.
Connect the RS-232 cable to the RS-232 connector on the right-terminated pre-
amplifier channel. For more information on linked preamplifier channels, see
Appendix: CAN Link and Multiple Evolution Two Preamplifiers, on page 51.

Save

This function enables you to save a copy of the current settings. The options are:
GO, BACK.
Enter the menu, then:
1.
Use the level control knob on the preamplifier channel front panel or up and
down keys (16) on the remote control to select:
2.
Press the enter button on the preamplifier channel front panel or the or enter
key (18) on the remote control. The front panel display (15) shows the default
mode:
GO.
3.
Press the enter button or key to save the settings The front panel display
reads:
SAVE.
GO
Saves a copy of current settings to memory, overwriting previously saved settings.

Software Clone

This function enables you to transfer operational software from one linked pream-
plifier channel to another. Software clone insures that, where desired, software for
multiple preamplifier channels is identical. The options are:
Enter the menu, then:
1.
Identify the clone transmitter and clone receiver. The clone transmitter is the
preamplifier channel that transmits the clone and the clone receiver(s) is/are
the preamplifier channel(s) that receive(s) the clone.
2.
Use the level control knob on the preamplifier chassis front panel of the clone
transmitter, or up and down keys (16) on the remote control to select:
CLONE.
3.
Press the enter button on the clone transmitter front panel or the enter key (18)
on the remote control The front panel display (15) reads:
.
45
SAVE.
NO, YES.
SOFTWARE
.
SW BEGIN
continued