Clone - Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER Owner's Reference Manual

FORCE RIGHT
Use to make a right channel respond as a left channel.
FORCE NONE
The preamplifier channel ignores balance selections. Use this option to set up
more than 2 preamplifier channels.
NO OVERRIDE
Return to
CHANNEL ASSIGN.
items.
For more information on linked preamplifiers, see Appendix: CAN Link and
Multiple Evolution Two Preamplifiers, on page 51.

Clone

This function enables you to transfer configured functions between linked pream-
plifier channels. There is no need to configure multiple menu choices for each pre-
amplifier channel. Clone insures that, where desired, the configuration of functions
for multiple preamplifier channels is identical. The option is:
Enter the menu, then:
1.
Identify the clone transmitter and clone receiver. The clone transmitter is the
preamplifier channel that transmits the clone and the clone receiver(s) is/are
the preamplifier channel(s) that receive(s) the clone.
2.
Use the level control knob on the preamplifier chassis front panel (1) of the
clone transmitter, or the up and down keys (16) on the remote control to select:
CLONE.
3.
Press the enter button on the preamplifier chassis front panel (1) of the clone
transmitter or the enter key (18) on the remote control
(15) reads:
CLONE BEGIN
4.
Press the enter button or the enter key again
reads:
CLONE TRANSMIT
5.
Press the enter button on the front panel of the clone transmitter. All clone
receivers go into stand-by mode, indicating that the clone is accomplished.
Note
The enter button on the remote control cannot be used to activate the clone function.
Serves the same function as
.
.
and the clone receiver display(s) read(s):
35
in all other menu
BACK
CLONE BEGIN.
The front panel display
.
The clone transmitter display
CLONE RECEIVE.
continued