Airstream Basecamp 2007 Owner's Manual page 94

APPLIANCES
Temperature
Press the plus TEMP button to raise the temperature. The Set indicator light will turn
on. Each time you press or hold the plus TEMP button, the temperature will go up 1
degree until it reaches 86°F (30°C).
NOTE: After 3 seconds, the Set indicator light will turn off an, the display will show the
current room temperature.
Press the minus TEMP button to lower the temperature. The Set indicator light will turn
on. Each time you press or hold the minus TEMP button, the temperature will go down
1° until it reaches 64°F (18°C).
NOTE: After 3 seconds, the Set indicator light will turn off and the display will show the
H
current room temperature.
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air conditioner turns off (the air
conditioner must be On):
1. Press TIMER. Indicator light will flash.
2. Press the plus or minus TEMP button to change the delay time from 1
to 24 hours.
3. Press TIMER again or wait 10 seconds. Indicator light will remain on.
Timer
To set the Timer to turn on the air conditioner, keeping previous settings:
1. Turn off air conditioner.
+
70
TEMP
A.
A. Set indicator light
2. Press TIMER. Indicator light will flash.
3. Press the plus or minus TEMP button to change delay time (1 to 24 hours).
4. Press TIMER again or wait 10 seconds. Indicator light will remain on.
To set the Timer to turn on the air conditioner, changing the previous settings:
1. Turn air conditioner on.
2. Adjust Mode to Cool, Fan Only, or Power Saver.
3. Adjust Fan Speed to Turbo, High or Low, or Auto.
4. Adjust temperature between 64°F (18°C) and 86°F (30°C). 5. Turn off air condi-
tioner.
6. Press TIMER. Indicator light will flash.
7. Press the plus or minus TEMP button to change delay time (1 to 24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light will remain on.
To clear Timer delay program: Press and hold TIMER for 3 seconds. Indicator light
will turn off.
NOTE: Air conditioner can be either on or off.
To see the remaining time (in hours):
1. Press TIMER once after it has been programmed.
2. While the display is showing the remaining time, you can press the plus or minus
TEMP button to increase or decrease the time.
H - 3