Airstream Basecamp 2007 Owner's Manual page 53

SETTING UP YOUR TENT
NOTE: Rear step/ramp must be stored before setting up tent.
1. Assemble all of the poles (Figures 1 A, 1 B, and 1 C). Set the poles with the black
end tips off to the side for now. DO NOT allow the shock cord to snap the pole sections
together, as this can damage the poles.
Figure 1A Figure 1B
2. Spread the BaseCamp tent body on the ground (make sure the pole sleeves are
facing up) and locate the ends of the three pole sleeves that run across the tent (Figure
2, inserts). NOTE: The pole sleeve ends can be found under the navy patches found
on either side of the doors.
Kel t y
3. Insert the longest of the three poles with grommet tips into the sleeve at the top of
the BaseCamp tent (Figure 3, the sleeve runs close to the opening that attaches to
your Airstream® trailer).
Figure 1C
4. Insert the medium pole into the middle pole sleeve. NOTE: There are TWO poles
sleeves under this navy flap. Make sure the medium pole uses the sleeve that runs
closest to the door (Figure 4).
5. Insert the remaining pole with grommet tips on both ends into the final pole sleeve
that runs the width of the BaseCamp tent (Figure 5).
Figure 2
D - 14
EXTERIOR
D
Figure 3
Figure 4
Figure 5