Smoke Alarm - Airstream Basecamp 2007 Owner's Manual

Ceiling Vent, Non Power
The vent is operated using the crank. Be sure vent is closed before travel. Lubricate
vent every six months with a light household oil.
Light Switches
Light switches are located on the front overhead and the rear of the trailer and are
labeled for your convenience.
To change the bulb in the round ceiling light, first remove the lens assembly. The lens
assembly is spring loaded and pops out of the fixture at its chrome ring. A small screw-
driver may be used, be careful not to scratch the chrome and be sure the bulb is cool
before attempting replacement. The bulb inserts into the ballast by two wire prongs.
Grasp the bulb with a piece of cloth and pull it gently straight out from its ballast. Insert
the new bulb, and replace the lens. The lens assembly has two grooves that must be
aligned to the light fixture before snapping the lens back into place.
Storage
All storage areas should have the heaviest items on the bottom and lighter items over-
head. All items should be packed to immobilize them as much as possible. This will
prevent damage to the interior due to shifting loads. After loading you should have the
skillets and can goods on the floor or bottom shelf, and the cereals and crackers in the
overhead areas. Use the unbreakable type plates and saucers, and consider storing
your dish towels around them. Better yet, use paper plates. Who wants to wash dishes
when on a trip or vacation?
SMOKE ALARM - FIREX MODEL B
Maple Chase Company
2820 Thatcher Road
Downers Grove, Illinois 60515-4040
IMPORTANT INFORMATION-SMOKE ALARM SAFETY CHECKLIST
1. Test your smoke alarm every week. To test the electronics, firmly depress the button.
To test that smoke reaches the sensor, blow smoke in a careful fire-safe manner into
your smoke alarm.
2. Your smoke alarm will not work without power. Never shut off its power or remove
the battery to quiet the alarm. FOR BATTERY-POWERED UNITS: When your smoke
alarm "beeps" about once a minute, the battery is weak. Immediately install a new
battery correctly. Be sure to use only batteries specified in Owner's Manual or on
unit. Test unit after installing a new battery.
3. Clean and vacuum the openings on your smoke alarm once a month.
4. Do not open the smoke alarm or try to repair it. For replacement information see the
WARRANTY in the Owner's Manual.
5. Verify you have the proper number of smoke alarms in your home and the correct
location for each one. A smoke alarm will not respond well in an incorrect location.
6. If your smoke alarm has one or more of these special features, please note:
• FALSE ALARM CONTROL (Model C): Pushing test/hush button reduces
sensitivity for up to 15 minutes, minimizing nuisance alarms,
• FLASHING LIGHT (Model E): Pushing test button turns flashing safety light
on. Very thick smoke may obscure light.
E - 2
INTERIOR
E